The new model is extended to wrap around the safety switch. This helps protect your hand from abrasion that can occur if your hand slides too far forward, which can happen with the Shockwave when firing high-brass loads. To learn more, see our Shockwave videos.
The RM Weld mounts with 2 screws onto the drilled and tapped receivers using the standard 4 hole pattern with 8-40 screws . The RM Weld uses the 2 outer holes for mounting. If your receiver is not drilled and tapped from the factory, this is simple job with any gunsmith.
Includes:
RM Weld
2 (8-40 × 1/4”) screws
The new model is extended to wrap around the safety switch. This helps protect your hand from abrasion that can occur if your hand slides too far forward, which can happen with the Shockwave when firing high-brass loads. To learn more, see our Shockwave videos.
The RM Weld mounts with 2 screws onto the drilled and tapped receivers using the standard 4 hole pattern with 8-40 screws . The RM Weld uses the 2 outer holes for mounting. If your receiver is not drilled and tapped from the factory, this is simple job with any gunsmith.
Includes:
RM Weld
2 (8-40 × 1/4”) screws
